Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Envoy and 2009 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the front spring and the front spring insulator in the J 45400 . See Special Tools .
- Turn the spring compressor adjusting screw (1) until the coil spring is compressed.
- Install the lower front spring insulator, front shock absorber upper bumper, front shock absorber boot, front shock retainer, front suspension washer on to the shock absorber.
- Install the shock absorber to the J 45400 . See Special Tools .
- Install the front suspension washer on the shock absorber.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.