Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 562 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 4.2L - INTRODUCTION)SPECIAL TOOLS AND EQUIPMENTSPECIAL TOOLS
2006 Isuzu Ascender S, 5.3 M, 4WD
Special Tools
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Special Tools
WARNING: This page is about a different car, the 2009 GMC Envoy and 2009 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
| Illustration | Tool Number/Description |
|---|---|
| CH 47976 Active Fuel Injector Tester (AFIT) |
|
| CH 48027 Digital Pressure Gage |
|
| CH 48096 EVAP Service Access Port Tool |
|
| GE 41415-50 Fuel Tank Cap Adapter |
|
| J 26792 HEI Spark Tester |
|
| J 34730-1A Fuel Pressure Gage |
|
| J 35616 GM-Approved Terminal Test Kit |
|
| J 35800-A Fuel Injector Cleaner |
|
| J 37088-A Fuel Line Disconnect Tool Set |
|
| J 37287 Fuel Line Shut-Off Adapters |
|
| J 38522 Variable Signal Generator |
|
| J 39021 Fuel Injector Coil and Balance Tester |
|
| J 39194-B Heated Oxygen Sensor Wrench |
|
| J 41413 EVAP Pressure and Purge Station |
|
| J 41413-200 Evaporative Emissions System Tester (EEST) |
|
| J 41413-SPT High Intensity White Light |
|
| J 41413-VLV EVAP Service Port Vent Fitting |
|
| J 41415-40 Fuel Tank Cap Adapter |
|
| J 42242 Fuel Pressure Gage Adapter |
|
| J 42598 Vehicle Data Recorder |
|
| J 42873-1 3/8 Fuel Line Shut-Off Valve |
|
| J 42873-2 5/16 Return Pipe Shut-Off Valve |
|
| J 42964-1 3/8 Fuel Pipe Shut-Off Valve |
|
| J 42964-2 5/16 Fuel Pipe Shut-Off Valve |
|
| J 44175 Fuel Composition Tester |
|
| J 45722 Fuel Sender Lock Ring Wrench |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.