SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 554 (ADJUSTABLE PEDAL SYSTEM)REPAIR INSTRUCTIONSACCELERATOR PEDAL ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Envoy and 2009 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Accelerator Pedal Assembly Removed
    GM1302012Courtesy of GENERAL MOTORS CORP.
  1. Position the accelerator pedal on the mounting studs.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the mounting nuts and tighten to 11 N.m (97 lb in).
    3. Fig 2: Locating Accelerator Pedal Mounting Bolt
    GM1334507Courtesy of GENERAL MOTORS CORP.
  3. Install the mounting bolt behind the accelerator pedal and tighten the mounting nuts to 11 N.m (97 lb in).
    4. Fig 3: Identifying Accelerator Pedal
    GM1301966Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.