Circuit/System Testing

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2009 GMC Envoy and 2009 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X5 harness connector at the DDM.
  2. Ignition ON, verify the scan tool Mirror Motor parameter is Idle.
    • If not the specified value, replace the DDM.
  3. Ignition OFF, connect the X5 harness connector at the DDM.
  4. Ignition ON, observe the scan tool Mirror Motor parameter while cycling the mirror directional switch between the up, down, left and right positions. The parameter should change between Idle, Up, Down, Left, and Right.
    • If the parameter does not cycle between the specified values, replace the outside rearview mirror switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.