Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 531 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM & NAVIGATION SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Isuzu Ascender S, 5.3 M, 4WD
Fastener Tightening Specifications
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2009 GMC Envoy and 2009 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Communication Interface Module Bracket Nut | 45 N.m | 33 lb ft |
| Digital Radio Antenna Bolt | 6 N.m | 53 lb in |
| Digital Radio Receiver Nut | 5 N.m | 44 lb in |
| Global Positioning System Antenna Screw | 2.5 N.m | 22 lb in |
| Mobile Telephone Microphone Screws | 0.8 N.m | 7 lb in |
| Navigation Antenna Nut | 6 N.m | 53 lb in |
| Personal Message Recorder Screws | 0.8 N.m | 7 lb in |
| Radio Antenna Cable Bolts | 8 N.m | 70 lb in |
| Radio Antenna Module Screw | 2.5 N.m | 22 lb in |
| Radio Front Speaker Screws | 2 N.m | 18 lb in |
| Radio Rear Speaker Screws | 2 N.m | 18 lb in |
| Radio Screws | 2 N.m | 18 lb in |
| Radio Speaker Amplifier Screw | 10 N.m | 88 lb in |
| Radio Upper Speaker Screws | 2 N.m | 18 lb in |
| Radio Volume Compensator Interior Noise Microphone screws | 0.8 N.m | 7 lb in |
| Video Display Bolts | 9 N.m | 80 lb in |
| Video Player Bracket Bolts | 10 N.m | 88 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.