Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Envoy and 2009 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Position the radio to the I/P.
- Connect the electrical connectors to the radio.
- Connect the radio antenna cable to the radio.
- Position the radio rear alignment locator (1) into the I/P substrate.
- Install the 3 screws that retain the radio to the I/P.
Tighten: Tighten the screws to 2 N.m (18 lb in).
- Install the accessory trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement (Chevrolet) or Instrument Panel Cluster Trim Plate Bezel Replacement (GMC) or Instrument Panel Accessory Trim Plate Replacement (GMC) .
- Install the lower closeout/insulator panel (GMC only). Refer to Instrument Panel Insulator Panel Replacement (GMC/Chevrolet) .
- If a replacement radio is installed, setup the radio. Refer to Control Module References .
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.