Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Envoy and 2009 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Antenna Assembly & Electrical Connectors
    GM1222548Courtesy of GENERAL MOTORS CORP.
  1. Install the antenna assembly from the top of the roof.
  2. Lower the antenna assembly to the roof panel, ensuring the anti-rotation pin is properly indexed.
  3. CAUTION: Refer to Fastener Caution .
  4. Tighten the retaining nut.

    Tighten:Β  Tighten the nut to 6 N.m (53 lb in).

  5. Connect the antenna electrical connectors.
  6. Install the headliner. Refer to Headlining Trim Panel Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.