Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 473 (CONFIGURABLE CUSTOMER CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSTEERING WHEEL CONTROLS INOPERATIVE (EQUINOX)COMPONENT TESTING
2006 Isuzu Ascender S, 5.3 M, 4WD
Component Testing
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Component Testing
WARNING: This page is about a different car, the 2008 Pontiac Torrent and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Refer to SIR Caution
.
- Ignition OFF, disconnect the harness connector at the suspect steering wheel control switch.
- Test for infinite resistance between the ignition terminal 3 and the signal terminal 4 with the switch in the open position.
- If less than specified value, replace the switch.
- Test for less than 5400 ohms between the signal terminal 4 and the ignition terminal 3 with the switch in the closed position.
- If greater than the specified value, replace the steering wheel control switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.