SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 468 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WIPER SYSTEM MODULE REPLACEMENT
2006 Isuzu Ascender S, 5.3 M, 4WD

Windshield Wiper System Module Replacement

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Windshield Wiper System Module Replacement
WARNING: This page is about a different car, the 2008 Pontiac Torrent and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Windshield Wiper Motor Module
GM1716297Courtesy of GENERAL MOTORS CORP.
Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .
1 Windshield Washer Arm Nut (Qty: 4)

Tighten:  28 N.m (21 lb ft)
2 Windshield Washer Arm Assembly
Tip: 
  • Position wiper blade assembly at the dot in lower portion of windshield blackout strip on driver side of vehicle.
  • Position wiper blade assembly at the dot in windshield pillar portion of windshield blackout strip on passenger side of vehicle.
3 Windshield Washer Module Bolt (Qty: 4)
Tip:  Remove the air inlet grille panel to access the wiper motor module. Refer to Air Inlet Grille Panel Replacement .

Tighten:  12 N.m (9 lb ft)
4 Windshield Washer Module Assembly
Tip: 
  1. Disconnect the electrical connector.
  2. After installation turn the key to RUN position and cycle wiper system to ensure motor is in the park position before installing the wiper arms.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.