SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 468 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT CONTAINER REPLACEMENT
2006 Isuzu Ascender S, 5.3 M, 4WD

Windshield Washer Solvent Container Replacement

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Windshield Washer Solvent Container Replacement
WARNING: This page is about a different car, the 2008 Pontiac Torrent and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Washer Solvent Container
GM1716308Courtesy of GENERAL MOTORS CORP.
Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .Preliminary Procedure: Remove the coolant surge tank bolt and set the surge tank aside in the engine compartment, leaving the coolant lines attached to the tank. Refer to Radiator Surge Tank Replacement .
1 Windshield Washer Reservoir Screw

Tighten:  3 N.m (25 lb in)
2 Windshield Washer Reservoir Bolt

Tighten:  6 N.m (53 lb in)
3 Windshield Washer Reservoir
Tip: 
  1. Drain the headlamp washer solvent into a suitable container by disconnecting the headlamp washer hose at the headlamp washer pump spout.
  2. Disconnect the washer hoses from the pump and container.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.