SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 464 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSVEHICLE COMMUNICATION INTERFACE MODULE (VCIM) X2 (UE1)
2006 Isuzu Ascender S, 5.3 M, 4WD

Vehicle Communication Interface Module (VCIM) X2 (UE1)

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Vehicle Communication Interface Module (VCIM) X2 (UE1)
WARNING: This page is about a different car, the 2008 Suzuki XL7, 2008 Pontiac Torrent, and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Vehicle Communication Interface Module (VCIM) X2 (UE1) Connector End View
GM814532Courtesy of GENERAL MOTORS CORP.
Vehicle Communication Interface Module (VCIM) X2 (UE1)

Pin Wire Circuit Function
1 0.5 OG/BK 1406 Remote Playback Device Left Audio Signal
2 0.5 L-BU 1405 Remote Playback Device Audio Common Signal
3 0.5 TN/BK 2500 High Speed GMLAN Serial Data Bus+
4 0.5 TN 2501 High Speed GMLAN Serial Data Bus-
5-7 - - Not Used
8 0.35 BARE 814 Drain Wire
9 0.5 GY 655 Cellular Microphone Signal
10 0.35 BARE 1489 Drain Wire
11-12 - - Not Used
Connector Part Information 
  • OEM: 917975-1
  • Service: 88952886
  • Description: 12-Way F .040/.070 Hybrid (WH)
Terminal Part Information 
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.