SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 464 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSTRANSMISSION CONTROL MODULE (TCM) X1 (AF33-5)
2006 Isuzu Ascender S, 5.3 M, 4WD

Transmission Control Module (TCM) X1 (AF33-5)

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Transmission Control Module (TCM) X1 (AF33-5)
WARNING: This page is about a different car, the 2008 Suzuki XL7, 2008 Pontiac Torrent, and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Transmission Control Module (TCM) X1 (AF33-5) Connector End View
GM1850885Courtesy of GENERAL MOTORS CORP.
Transmission Control Module (TCM) X1 (AF33-5)

Pin Wire Circuit Function
1 RD/WH 540 Battery Positive Voltage
2-4 - - Not Used
5 OG/BK 1786 Ignition Lock CylinderControl Actuator Signal
6 TN 2501 High Speed GMLAN Serial Data Bus-
7 TN/BK 2500 High Speed GMLAN Serial Data Bus+
8 TN/BK 2500 High Speed GMLAN Serial Data Bus+
9 BK/WH 451 Ground
10 - - Not Used
11 PK 1339 Ignition Voltage
12 BN 4 Accessory Voltage
13 - - Not Used
14 TN 2501 High Speed GMALN Serial Data Bus-
15-16 - - Not Used
Connector Part Information 
  • OEM: 7283-9133-30
  • Service:
  • Description: 16-Way F 0.64/1.5 Series Sealed (BK)
Terminal Part Information 
  • Terminal/Tray:
  • Pins:
  • Core/Insulation Crimp:
  • Pins:
  • Core/Insulation Crimp:
  • Release Tool/Test Probe:
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.