SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 464 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSPOWER WINDOW SWITCH - MAIN X1
2006 Isuzu Ascender S, 5.3 M, 4WD

Power Window Switch - Main X1

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Power Window Switch - Main X1
WARNING: This page is about a different car, the 2008 Suzuki XL7, 2008 Pontiac Torrent, and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Power Window Switch - Main X1 Connector End View
GM1519696Courtesy of GENERAL MOTORS CORP.
Power Window Switch - Main X1

Pin Wire Circuit Function
1 2.0 PU 171 Power Window Master Switch Right Rear Down Signal
2 0.35 PU/WH 6816 Indicator Dimming Control
3 2.0 L-GN 170 Power Window Master Switch Right Rear Up Signal
4 2.0 D-BU 1307 Power Window Master Switch Lockout Control
5 2.0 L-BU 166 Power Window Master Switch Right Front Up Signal
6 2.0 TN 167 Power Window Master Switch Right Front Down Signal
Connector Part Information 
  • OEM: 7283-6466-40
  • Service: See Catalog
  • Description: 6-Way F YESC 2.8MM (GY)
Terminal Part Information 
  • Pins: 1, 3-6
  • Terminal/Tray: 7116-4112-02/9
  • Core/Insulation Crimp: C/D
  • Release Tool/Test Probe: 12094430/J-35616-35 (VT)
  • Pins: 2
  • Terminal/Tray: 7116-4110-02/9
  • Core/Insulation Crimp: E/C
  • Release Tool/Test Probe: 12094430/J-35616-4A (PU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.