SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 464 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSBODY CONTROL MODULE (BCM) X2
2006 Isuzu Ascender S, 5.3 M, 4WD

Body Control Module (BCM) X2

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Body Control Module (BCM) X2
WARNING: This page is about a different car, the 2008 Suzuki XL7, 2008 Pontiac Torrent, and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Body Control Module (BCM) X2 Connector End View
GM1664496Courtesy of GENERAL MOTORS CORP.
Body Control Module (BCM) X2

Pin Wire Circuit Function
1 0.8 OG 1732 Inadvertent Power Supply Voltage
2 0.8 RD/WH 1240 Battery Positive Voltage
3 0.8 GY 8 Instrument Panel Lamp Supply Voltage
4-7 - - Not Used
8 0.35 BN/WH 301 Park Lamp Switch On Signal
9-10 - - Not Used
11 0.35 L-GN/BK 1137 DRL Ambient Light Sensor Signal
12 0.35 WH 103 Headlamp Switch ON Signal
13-16 - - Not Used
17 0.35 D-GN 306 Headlamp Switch Headlamps OFF Signal
18-20 - - Not Used
21 0.35 L-BU 1788 Traction Control Switch Signal
22 0.35 PU/WH 5905 Key Capture/Column Lock Shift Position Signal
23-25 - - Not Used
Connector Part Information 
  • OEM: HITPB-25-B-S
  • Service: See Catalog
  • Description: 25-Way F Receptacle 0.64 2.8 Unsealed (WH)
Terminal Part Information 
  • Pins: 1-3
  • Terminal/Tray: SNAC-A061T-M2.8/20
  • Core/Insulation Crimp: E/A
  • Release Tool/Test Probe: 12094429/J-35616-4A (PU)
  • Pins: 8, 11-12, 17, 21
  • Terminal/Tray: SNAC3-A021T-M0.64/20
  • Core/Insulation Crimp: J/J
  • Release Tool/Test Probe: 12094429/J-35616-64B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.