Electronic Power Steering Motor Control Module Replacement

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Electronic Power Steering Motor Control Module Replacement
WARNING: This page is about a different car, the 2008 Pontiac Torrent and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Electronic Power Steering Motor Control Module
GM1848011Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the left side instrument panel outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement - Left Side
  2. Remove the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  3. Remove the driver knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement .
1 Electronic Power Steering Motor Control Module Bolt (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:Β  11.5 N.m (102 lb in)

2 Electronic Power Steering Motor Control Module
Procedure:Β 
Disconnect any electrical connectors as needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.