Door Lock Switch Replacement

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Door Lock Switch Replacement
WARNING: This page is about a different car, the 2008 Pontiac Torrent and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Power Door Lock Switch
GM1719779Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Fastener Tightening Specifications:Β  Refer to Fastener Tightening SpecificationsΒ .

Preliminary Procedure

  1. Remove front door extension trim panel. Refer to Upper Extension Trim Panel Replacement (Front Side Door) or Upper Extension Trim Panel Replacement (Rear Side Door) .
  2. Remove front door handle bezel. Refer to Door Handle Bezel Replacement (Rear Side Door) or Door Handle Bezel Replacement (Front Side Door) .
  3. Remove front door trim panel. Refer to Front Side Door Trim Panel Replacement .
1 Front Side Door Locking System Switch Assembly
Tip:Β 
  1. Disconnect electrical connector.
  2. Use a flat-bladed tool to pry switch from door handle assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.