SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 447 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)REPAIR INSTRUCTIONSCOMMUNICATION INTERFACE MODULE BATTERY REPLACEMENT
2006 Isuzu Ascender S, 5.3 M, 4WD

Communication Interface Module Battery Replacement

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Communication Interface Module Battery Replacement
WARNING: This page is about a different car, the 2008 Pontiac Torrent and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Communication Interface Module & Battery
GM1720127Courtesy of GENERAL MOTORS CORP.
Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Remove the driver seat. Refer to Front Seat Replacement - Bucket .
  2. Remove the left carpet retainer. Refer to Front Carpet Retainer Replacement .
  3. Remove the left lower center pillar molding. Refer to Center Pillar Lower Garnish Molding Replacement .
  4. Move the carpet back enough to gain access to the communication interface module battery.
1 Communication Interface Module Battery Nut (Qty: 3)

Tighten:  10 N.m (89 lb in)
2 Communication Interface Module Battery
Tip:  Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.