Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 446 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Isuzu Ascender S, 5.3 M, 4WD
Fastener Tightening Specifications
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2008 Pontiac Torrent and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Air Conditioning (A/C) Evaporator Line Clamp to Battery Tray Nut | 15 N.m | 11 lb ft |
| Battery Hold Down Bolt | 15 N.m | 11 lb ft |
| Battery Tray Bolt | 15 N.m | 11 lb ft |
| Battery Tray Support Bracket Bolt | 25 N.m | 18 lb ft |
| Generator Bolt | 50 N.m | 37 lb ft |
| Generator Bracket Bolt | 50 N.m | 37 lb ft |
| Generator Terminal Nut (LNJ) | 20 N.m | 15 lb ft |
| Generator Wiring Harness to Generator Nut (LY7) | 20 N.m | 15 lb ft |
| Negative Battery Cable Ground Terminal to Transaxle Stud Nut | 45 N.m | 33 lb ft |
| Negative Battery Cable Ground Terminal to Wheelhouse Stud Nut | 12 N.m | 106 lb in |
| Negative Battery Cable Terminal Nut | 17 N.m | 13 lb ft |
| Positive Battery Cable Terminal Nut | 17 N.m | 13 lb ft |
| Positive Battery Cable Terminal to Starter Solenoid Nut | 10 N.m | 89 lb in |
| Positive Battery Cable Terminal to Underhood Bussed Electrical Center (UBEC) Nut | 15 N.m | 11 lb ft |
| Starter Bolt (LNJ) | 43 N.m | 32 lb ft |
| Starter Bolt (LY7) | 50 N.m | 37 lb ft |
| Torque Converter Cover Bolt (LNJ) | 8 N.m | 71 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.