SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 446 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSBATTERY BOX REPLACEMENTINSTALLATION PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Pontiac Torrent and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Cooling Air Inlet Duct
    GM1822913Courtesy of GENERAL MOTORS CORP.
  1. Position the battery tray to the vehicle.
    2. IMPORTANT: Fully insert the duct into the hole on the battery tray past the second molded in ridge, stopping at the flange.
  2. Connect the battery cooling air inlet duct to the battery tray.
    3. Fig 2: Identifying Battery Tray Bolts
    GM1822914Courtesy of GENERAL MOTORS CORP.
  3. Set the battery tray completely in place.
    4. NOTE: Refer to Fastener Notice .
  4. Install the battery tray bolts.

    Tighten:  Tighten the bolts to 15 N.m (11 lb ft).

    5. Fig 3: View Of Battery Box
    GM1822907Courtesy of GENERAL MOTORS CORP.
  5. Install the A/C evaporator outlet line clamp to the battery tray stud.
  6. Install the A/C evaporator line clamp nut at the battery tray.

    Tighten:  Tighten the nut to 15 N.m (11 lb ft).

  7. Install the battery. Refer to Battery Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.