Removal Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the moveable roof panel. Refer to Moveable Roof Panel Assembly ReplacementΒ .
  2. Remove the moveable roof panel actuator cover. Refer to Moveable Roof Panel Actuator Cover ReplacementΒ .
  3. Fig 1: Locating Moveable Roof Panel Control Module Retainer
    GM1222238Courtesy of GENERAL MOTORS CORP.
  4. Depress the retainer (1) on the moveable roof panel control module.
  5. Slide the control module towards the motor/actuator assembly to remove the module from the keyhole slots.
  6. Disconnect the electrical connectors from the moveable roof panel control module.
  7. Remove the module from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.