Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 401 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSMEMORY SEAT CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD
Removal Procedure
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 3 seat switch bezel screws. Refer to Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement .
- Remove 4 nuts that attach the seat pan to the seat assembly.
- Remove the clip from the front outboard seat pan stud. Discard the clip.
- Lift the seat pan up in order to allow access to the seat control module retaining screw.
- Remove the seat control module retaining screw.
- Disconnect the electrical connectors from the seat control module as necessary.
- Remove the seat control module from the seat assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.