Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK PANEL REPLACEMENT - FRONTINSTALLATION PROCEDURE

2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Seat Back Panel - Front

Courtesy of GENERAL MOTORS CORP.

Install the seat back over the top of the seat-back frame.

Fig 2: Locating Front Seat Back Panel Side Push Pins

Courtesy of GENERAL MOTORS CORP.

Install the panel to the seat-back frame with 2 push-pin fasteners (1) to each side of the panel.

Fig 3: Locating Front Seat Back Panel Bottom Push Pin

Courtesy of GENERAL MOTORS CORP.

Install the push-pin fastener (1) to the bottom of the panel.

Fig 4: Locating Lumbar Cables At Front Seat Back Panel Clips

Courtesy of GENERAL MOTORS CORP.

Install the lumbar cables to the panel clips.
Install the front seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
Install the front bucket seat assembly to the vehicle. Refer to Seat Replacement - Front Bucket .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.