SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK FRAME REPLACEMENT - FRONTREMOVAL PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Removal Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat assembly from the vehicle. Refer to Seat Replacement - Front Bucket .
  2. Remove the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  3. Remove the front seat back. Refer to Seat Back Replacement - Front .
  4. Remove the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
  5. Remove the front seat back panel. Refer to Seat Back Panel Replacement - Front .
  6. Remove the lumbar assembly. Refer to Lumbar Replacement - Front Seat .
  7. Remove the seat belt and retractor assembly. Refer to Seat Belt Replacement - Front .
    8. Fig 1: Locating Inflatable Side Impact Module To Seat Back Frame Screws
    GM753528Courtesy of GENERAL MOTORS CORP.
  8. Remove 2 screws (1) securing the inflatable side impact module to the seat back frame.
    9. Fig 2: Locating Side Impact Module Tub To Seat Back Frame Push Pins
    GM753530Courtesy of GENERAL MOTORS CORP.
  9. Remove the 2 push pins (1) securing the side impact module tub to the seat back frame.
    10. Fig 3: Identifying Lumbar & SIR Wiring At Seat Back Frame
    GM753527Courtesy of GENERAL MOTORS CORP.
  10. Remove the SIR wiring harness (1) from the seat back frame.
  11. Remove the lumbar wiring harness (3) from the seat back frame.
  12. Remove the wiring harness clips (2) from the seat back frame.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.