SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4 (SEAT SYSTEM)REPAIR INSTRUCTIONSLUMBAR SUPPORT CABLE REPLACEMENTINSTALLATION PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Lumbar Cable Routing
    GM755853Courtesy of GENERAL MOTORS CORP.
  1. Hook the cable end into the lumbar mechanism.
    2. Fig 2: Accessing Lumbar Mechanism
    GM755852Courtesy of GENERAL MOTORS CORP.
  2. Install the cable to the lumbar spring.
    3. Fig 3: Locating Lumbar Cable Clip On Lower Seat Back
    GM755850Courtesy of GENERAL MOTORS CORP.
  3. Install the lumbar cable (2) in the cable clip (1) located on the lower seat back.
    4. Fig 4: Locating Cable To Seat Adjuster Screws
    GM755848Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.