SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 386 (ANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)REPAIR INSTRUCTIONSBRAKE PRESSURE MODULATOR VALVE BRACKET REPLACEMENT
2006 Isuzu Ascender S, 5.3 M, 4WD

Brake Pressure Modulator Valve Bracket Replacement

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Brake Pressure Modulator Valve Bracket Replacement
WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Brake Pressure Modulator Valve Bracket Components
GM1707573Courtesy of GENERAL MOTORS CORP.
Callout Component Name
CAUTION: Refer to Brake Fluid Irritant Caution .
Preliminary Procedures: Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
1 Brake Pressure Modulator Valve (BPMV) Electrical Connector
2 Clip
Tip:  Before working on the brake pipes, release the locking tab on the retaining clip.
3 Fitting (Qty: 6)
NOTE: Refer to Fastener Notice .

Tip: 
  1. Before removing the brake pipes from the ABS module, clean all dirt and debris from the ABS module.
  2. Cap or plug the brake pipes to prevent contamination of the brake system and fluid leaks.
  3. Bleed the brake system. Refer to Antilock Brake System Automated Bleed Procedure .

Tighten:  25 N.m (18 lb ft)
4 Bolt (Qty: 3)

Tighten:  20 N.m (15 lb ft)
5 Bolt

Tighten:  11 N.m (97 lb in)
6 BPMV Mounting Bracket
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.