Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 386 (ANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)DIAGNOSTIC INFORMATION & PROCEDURESTRACTION OFF INDICATOR MALFUNCTIONCIRCUIT/SYSTEM TESTING
2006 Isuzu Ascender S, 5.3 M, 4WD
Circuit/System Testing
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Diagnose all vehicle DTCs before using this diagnostic.
The malfunction must be present during diagnosis in order to prevent unnecessary parts replacement.
The malfunction must be present during diagnosis in order to prevent unnecessary parts replacement.
Ignition OFF for 5 seconds, Ignition ON, observe that the traction off indicator functions by illuminating for 2 seconds then turns OFF.
- If the traction OFF indicator does not illuminate, with the scan tool, select instrument panel special functions Display Test. Command the instrument panel lamps ON and OFF. Verify the TC lamp turns ON and OFF.
- If the TC warning lamp does not turn OFF, replace the IPC.
- If the TC warning lamp does turn OFF, replace the EBCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.