SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 379 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSTRANSFER CASE SHIFT CONTROL MODULE X2 (NP8)
2006 Isuzu Ascender S, 5.3 M, 4WD

Transfer Case Shift Control Module X2 (NP8)

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Transfer Case Shift Control Module X2 (NP8)
WARNING: This page is about a different car, the 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Transfer Case Shift Control Module X2 (NP8) Connector End View
GM73152Courtesy of GENERAL MOTORS CORP.
Transfer Case Shift Control Module X2 (NP8)

Pin Wire Circuit Function
A1 0.35 PU 401 Signal Low - Front
A2 0.35 YE 400 Signal High - Front
A3-A7 - - Not Used
A8 0.35 GY 605 5-Volt Reference
B1 0.35 L-BU 2221 Signal High - Rear
B2 0.35 D-GN 2222 Signal Low - Rear
B3-B5 - - Not Used
B6 0.5 BK/WH 1695 Axle Switch Signal
B7 - - Not Used
B8 0.35 GY 596 5-Volt Reference
Connector Part Information 
  • OEM: 12084945
  • Service: 12084945
  • Description: 16-Way F Micro-Pack 100 Series Unsealed (GY)
Terminal Part Information 
  • Pins: A1-A2, A8, B1-B2, B6, B8
  • Terminal/Tray: 12146447/3
  • Core/Insulation Crimp: E/C
  • Release Tool/Test Probe: 12031876-1/J-35616-6 (BN)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.