SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 379 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSINFLATABLE RESTRAINT FRONT PASSENGER PRESENCE SYSTEM (PPS) MODULE
2006 Isuzu Ascender S, 5.3 M, 4WD

Inflatable Restraint Front Passenger Presence System (PPS) Module

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Inflatable Restraint Front Passenger Presence System (PPS) Module
WARNING: This page is about a different car, the 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Inflatable Restraint Front Passenger Presence System (PPS) Module Connector End View
GM1550231Courtesy of GENERAL MOTORS CORP.
Inflatable Restraint Front Passenger Presence System (PPS) Module

Pin Wire Circuit Function
1 0.35 D-BU 2307 Passenger Air Bag On Indicator Control (AL0)
2 0.35 D-GN 2308 Passenger Air Bag Off Indicator Control (AL0)
3 - - Not Used
4 0.35 PU 5611 Passenger Seat Belt Tension Sensor Signal
5 0.35 BK/WH 1751 Ground
6 0.35 YE 5608 Occupant Pressure Sensor Signal
7 0.35 D-GN 5609 Occupant Pressure Sensor Voltage Reference
8 - - Not Used
9 0.35 YE 1139 Ignition 1 Voltage
10-13 - - Not Used
14 0.35 TN 5613 Passenger Seat Belt Tension Sensor Low Reference
15 0.35 GY 5610 Occupant Pressure Sensor Low Reference
16 0.35 L-BU 5612 Passenger Seat Belt Tension Sensor Voltage Reference
17 - - Not Used
18 0.35 PK 2306 Occupant Sensor - Serial Data Link
Connector Part Information 
  • OEM: 15431682
  • Service: See Catalog
  • Description: 18-Way F Micro-Pack 100W Series Sealed (BK)
Terminal Part Information 
  • Pins: 1-2, 4-7, 9, 14-16, 18
  • Terminal/Tray: Service With Terminated Lead
  • Core/Insulation Crimp: N/A
  • Release Tool/Test Probe: 12122523/J-35616-6 (BN)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.