SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 376 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSBATTERY POSITIVE CABLE REPLACEMENT (4.2L ENGINE)INSTALLATION PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Positive Battery Cable Boot
    GM1804781Courtesy of GENERAL MOTORS CORP.
  1. Position the battery positive cable in the engine compartment.
  2. Install the positive battery cable to the generator.
    3. NOTE: Refer to Fastener Notice .
  3. Install the positive battery cable terminal nut (1).

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  4. Position the positive battery cable boot (3).
    5. Fig 2: Locating Negative Battery Cable At Block & Positive At Starter
    GM1804782Courtesy of GENERAL MOTORS CORP.
  5. Install the positive battery cable terminal (2) to the starter.
  6. Install the positive battery cable nut (1) to the starter.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  7. Install the battery positive cable harness to the fir-tree retainer on the PCM bracket.
  8. Install the battery positive cable into the conduit.
  9. Connect the battery cable conduit to the conduit retaining clip.
    10. Fig 3: Identifying Positive Battery Cable Terminal At Junction Block
    GM1804778Courtesy of GENERAL MOTORS CORP.
  10. Install the positive battery cable terminal (2) to the junction block.
  11. Tighten the positive battery cable terminal bolt (1) at the junction block.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    12. Fig 4: View Of Battery, Cables & Battery Control Module
    GM1804767Courtesy of GENERAL MOTORS CORP.
  12. Install the positive battery cable (1) to the battery.
  13. Tighten the battery positive cable bolt.

    Tighten:  Tighten the bolt to 15 N.m (11 lb ft).

  14. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.