SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 291 (ENGINE ELECTRICAL)REPAIR INSTRUCTIONSBATTERY POSITIVE CABLE REPLACEMENT (5.3L ENGINE)INSTALLATION PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Saab 9-7X. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Cable Connections At Starter
    GM1804775Courtesy of GENERAL MOTORS CORP.
  1. Install the positive battery cable to the conduit.
  2. Install the positive battery cable terminal (3).
    3. NOTE: Refer to Fastener Notice .
  3. Install the positive battery cable terminal nut (2) to the starter.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  4. Install the positive battery cable clip (1) to the bracket.
    5. Fig 2: View Of Negative Battery Cable Ground Terminal At Engine Block
    GM1804776Courtesy of GENERAL MOTORS CORP.
  5. Install the positive battery cable channel locating pin (4) to the oil pan.
  6. Install the positive battery cable channel bolt (3).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  7. Install the engine protection shield. Refer to Engine Protection Shield Replacement .
    8. Fig 3: View Of Negative Battery Cable Ground Terminal Bolt At Shock Tower, Positive At Generator
    GM1804773Courtesy of GENERAL MOTORS CORP.
  8. Install the positive battery cable terminal (3) to the generator.
  9. Install the positive battery cable nut (1).

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  10. Position the positive battery cable boot (2).
  11. Close the clips (4) on the retaining brackets.
    12. Fig 4: Identifying Positive Battery Cable Terminal At Junction Block
    GM1804778Courtesy of GENERAL MOTORS CORP.
  12. Install the positive battery cable terminal (2) to the junction block.
  13. Tighten the positive battery cable terminal bolt (1) at the junction block.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    14. Fig 5: View Of Battery, Cables & Battery Control Module
    GM1804767Courtesy of GENERAL MOTORS CORP.
  14. Position the positive battery cable (1) to the battery.
  15. Tighten the battery positive cable bolt.

    Tighten:  Tighten the bolt to 15 N.m (11 lb ft).

  16. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.