SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 272 (CELLULAR, ENTERTAINMENT, AND NAVIGATION)REPAIR INSTRUCTIONSVIDEO DISPLAY REPLACEMENTREMOVAL PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Removal Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Saab 9-7X. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Do not attempt to service the video display assembly components.
    The video display is serviced only as an assembly.
  1. Turn the ignition switch to the OFF position.
    2. Fig 1: Removing Bolt Cover Bezel
    GM792153Courtesy of GENERAL MOTORS CORP.
  2. Using a plastic flat-bladed tool, carefully remove the bolt cover bezel.
    3. Fig 2: Identifying Video Assembly
    GM823869Courtesy of GENERAL MOTORS CORP.
  3. Fully loosen the two rear retaining bolts. The bolts will remain attached to the video assembly.
  4. In order to expose the two front retaining bolts, adjust the video display screen to a full open position.
  5. Fully loosen the front retaining bolts. The bolts will remain attached to the video assembly.
  6. Close the video display screen.
  7. Slowly lower the front of the video assembly to release the retaining fastener (3).
  8. Support the video assembly and disconnect the electrical connector (2).
  9. Adjust the video assembly in order to release the T-hook (1) from the video player bracket.
  10. Remove the video assembly from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.