SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 272 (CELLULAR, ENTERTAINMENT, AND NAVIGATION)REPAIR INSTRUCTIONSGLOBAL POSITIONING SYSTEM (GPS) ANTENNA REPLACEMENT (MODULE ASSEMBLY RADIO ANTENNA)REMOVAL PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Removal Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Saab 9-7X. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: It is not necessary to lower the steering column to remove the radio antenna module.
  1. Remove the navigational radio. Refer to Radio Replacement .
    2. Fig 1: Identifying Navigational Radio
    GM1226967Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector from the navigational radio (1).
  3. Partially remove the instrument panel (I/P) assembly from the I/P structure, to gain access to the antenna module retaining screw. Refer to Instrument Panel Assembly Replacement .
  4. Remove the screw retaining the radio antenna module to the cross-car beam (2).
  5. Remove the antenna module from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.