Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 271 (INSTRUMENT PANEL AND CONSOLE TRIM)
2006 Isuzu Ascender S, 5.3 M, 4WD
Section 271 (Instrument Panel And Console Trim)
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Section 271 (Instrument Panel And Console Trim)
WARNING: This page is about a different car, the 2008 Saab 9-7X. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Repair Instructions
- Instrument Panel Insulator Panel Replacement - Right Side
- Instrument Panel Insulator Panel Replacement - Left Side
- Driver Knee Bolster Panel Replacement
- Knee Bolster Replacement
- Instrument Panel Accessory Trim Plate Replacement - Left Side
- Instrument Panel Accessory Trim Plate Replacement
- Instrument Panel Cluster Trim Plate Bezel Replacement
- Instrument Panel Compartment Door Replacement
- Instrument Panel Cup Holder Replacement
- Instrument Panel Upper Trim Pad Replacement
- Instrument Panel Assembly Replacement
- Instrument Panel Carrier Replacement
- Front Floor Console Compartment Replacement
- Console Shift Lever Bezel Replacement
- Console Replacement
- Floor Console Bracket Replacement
- Roof Console Replacement
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.