Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 24 (ENGINE CONTROL SYSTEM - 4.2L (INTRODUCTION))SPECIAL TOOLS AND EQUIPMENTSPECIAL TOOLS
2006 Isuzu Ascender S, 5.3 M, 4WD
Special Tools
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Special Tools
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Number/Description |
|---|---|
| J 23738-A Vacuum Pump |
|
| J 26792 Spark Plug Tester |
|
| J 34142 B Unpowered Test Lamp |
|
| J 34730-1A Fuel Pressure Gage |
|
| J 34730-405 Injector Test Lamp |
|
| J 35616-A Connector Test Adapter Kit |
|
| J 35800-A Fuel Injector Cleaner |
|
| J 36169-A Fused Jumper Wire |
|
| J 36169-HD Heavy Duty Fused Jumper |
|
| J 37088-A Tool Set, Fuel Line Quick-Connect Separator |
|
| J 37287 Fuel Pipe Shut-Off Adapters |
|
| J 39021 Injector Tester |
|
| J 39194-B Heated Oxygen Sensor Wrench |
|
| J 39765 Fuel Sender Locknut Wrench |
|
| J 41413-200 Evaporative Emissions System Tester (EEST) |
|
| J 41413-SPT High Intensity White Light |
|
| J 41413-VLV EVAP Service Port Vent Fitting |
|
| J 41415-40 Fuel Tank Cap Adapter |
|
| J 41416 Ultrasonic Leak Detector |
|
| J 43094 Spark Plug Boot Puller |
|
| J 42598 Vehicle Data Recorder |
|
| J 44175 Fuel Composition Tester |
|
| J 44402 Fuel Tank Sending Unit Wrench |
|
| P/N 7000081 Tech 2 Diagnostic Scan Tool |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.