SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 223 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 5.3L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSAIR CLEANER ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Air Filter Housing/Washer Solvent Tank Assembly & Washer Pump Hoses
    GM1361746Courtesy of GENERAL MOTORS CORP.
  1. Install the lower air filter housing/washer solvent tank assembly (2) onto the mounting studs.
  2. Connect the washer pump hoses (3) to the washer pumps.
    3. NOTE: Refer to Fastener Notice .
  3. Install the 2 retaining nuts (1) to the mounting studs on the air cleaner housing/washer solvent tank assembly.

    Tighten:  Tighten the nuts to 15 N.m (11 lb ft).

    4. Fig 2: View Of Headlamp Washer Hose At Headlamp Washer Pump
    GM1362808Courtesy of GENERAL MOTORS CORP.
  4. If applicable, connect the washer hose to the headlamp washer pump located on the lower air cleaner housing/washer solvent tank.
    5. Fig 3: Locating Electrical Connectors
    GM907812Courtesy of GENERAL MOTORS CORP.
  5. Connect the following electrical connectors:
    • The windshield washer pump (1)
    • The headlamp washer pump (2)
    • The low solvent level sensor (4)
    • The lift gate washer pump (6)
  6. Install the wire harness for the washer solvent level sensor to the wire harness retaining clips (3, 5).
    7. Fig 4: Exploded View Of Air Cleaner Assembly
    GM1217755Courtesy of GENERAL MOTORS CORP.
  7. Install the following components to the lower air cleaner housing/washer solvent tank assembly (4). Refer to Air Cleaner Element Replacement .
    • The air cleaner cover (2)
    • The filter element (6)
    • The mass air flow (MAF)/intake air temperature (IAT) sensor (3)
    • The air inlet duct (5)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.