SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 223 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 5.3L - INTRODUCTION (2 OF 2))COMPONENT LOCATORENGINE CONTROLS CONNECTORSMASS AIR FLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR
2006 Isuzu Ascender S, 5.3 M, 4WD

Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor
WARNING: This page is about a different car, the 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Connector End View
GM366067Courtesy of GENERAL MOTORS CORP.
Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Connector Parts Information

Connector Part Information 
  • OEM: 15305555
  • Service: 15306113
  • Description: 5-Way GT 150 Series Sealed (BK)
Terminal Part Information 
  • Terminal/Tray: 15326267/19
  • Core/Insulation Crimp: E/4
  • Release Tool/Test Probe: 15315247/J-35616-2A (GY)
Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Connecter Terminal Identification

Pin Wire Color Circuit No. Function
A BK 2760 Low Reference
B TN 472 IAT Sensor Signal
C BK 450 Ground
D PK 239 Ignition 1 Voltage
E YE 492 MAF Sensor Signal
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.