SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 214 (DISC BRAKE SYSTEM)REPAIR INSTRUCTIONSBRAKE CALIPER BRACKET REPLACEMENT - FRONTINSTALLATION PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Caliper Bracket Bushings
    GM788344Courtesy of GENERAL MOTORS CORP.
  1. Install the guide pin seals on the mounting bracket.
  2. If the guide pins and brake pad retaining clips are to be reused, use denatured alcohol to clean them.
  3. Dry the brake guide pins and brake pad retaining clips with non-lubricated, filtered air.
    4. Fig 2: View Of Brake Caliper Guide Pin
    GM156329Courtesy of GENERAL MOTORS CORP.
  4. Apply high temperature silicone brake lubricant to the brake caliper guide pins. DO NOT apply the lubricant to the brake pad retaining clips.
    5. Fig 3: View Of Rotor & Caliper
    GM788768Courtesy of GENERAL MOTORS CORP.
  5. Install the brake caliper mounting bracket.
    6. NOTE: Refer to Fastener Notice .
  6. Install the caliper mounting bracket bolts.

    Tighten:  Tighten the brake caliper mounting bracket bolts to 150 N.m (110 lb ft).

    7. Fig 4: View Of Caliper & Related Components
    GM783127Courtesy of GENERAL MOTORS CORP.
  7. Install the front brake pad hardware to the brake caliper mounting bracket.
    8. Fig 5: View of Brake Pads
    GM788397Courtesy of GENERAL MOTORS CORP.
  8. Install the brake pads to the brake caliper mounting bracket.
    9. Fig 6: View Of Rotor & Caliper
    GM788768Courtesy of GENERAL MOTORS CORP.
  9. Install the brake caliper assembly. Refer to Front Brake Caliper Replacement .
  10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  11. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
    12. CAUTION: Refer to Firm Brake Pedal Caution.
  12. Pump the brake pedal slowly and firmly in order to seat the brake pads.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.