SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 212 (ANTILOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)REPAIR INSTRUCTIONSWHEEL SPEED SENSOR RING REPLACEMENT - REARINSTALLATION PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of J 45860 & J 8092 Wheel Speed Sensor Ring Installation Tools
    GM885621Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel speed sensor ring using the J 45860  (1) and the J 8092  (2).
  2. Drive the wheel speed sensor ring into the axle housing until the tool bottoms against the tube.
    3. Fig 2: View Of Axle Shaft Bearing & Installation Tools J 23690 Or J 29709 & J 8092
    GM695758Courtesy of GENERAL MOTORS CORP.
  3. Install the axle shaft bearing using the J 23690  (1) and the J 8092  (2).
  4. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
    5. Fig 3: View Of Axle Shaft Seal & J 21128
    GM885624Courtesy of GENERAL MOTORS CORP.
  5. Install the axle shaft seal using the J 21128  .
  6. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
  7. Install the axle shaft. Refer to Rear Axle Shaft Replacement .
  8. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.0/8.6 Inch Axle) or Rear Axle Housing Cover and Gasket Replacement (9.5 Inch Axle) .
  9. Install the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement .
  10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  11. Fill the rear axle. Refer to Lubricant Replacement - Rear Drive Axle (9.5 LD Inch Axle) .
  12. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.