Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 211 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 4.2L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSMANIFOLD ABSOLUTE PRESSURE SENSOR REPLACEMENTREMOVAL PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD
Removal Procedure
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
- Turn OFF the ignition.
- Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
- Press the retainer locking tabs inward, then pull the retainer (1) up to remove it.
- Remove the MAP sensor (2).
- Inspect the MAP sensor seal for damage and replace as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.