SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 21 (ANTILOCK BRAKE SYSTEM AND TRACTION CONTROL SYSTEM)SCHEMATIC AND ROUTING DIAGRAMSABS SCHEMATIC ICONS
2006 Isuzu Ascender S, 5.3 M, 4WD

ABS Schematic Icons

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION ABS Schematic Icons
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
ABS Schematic Icons

Icon Icon Definition
GM296880Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Twisted-pair wires provide an effective shield that helps protect sensitive electronic components from electrical interference. If the wires were covered with shielding, install new shielding.
In order to prevent electrical interference from degrading the performance of the connected components, you must maintain the proper specification when making any repairs to the twisted-pair wires shown :
  • The wires must be twisted a minimum of 9 turns per 31 cm (12 in) as measured anywhere along the length of the wires.
  • The outside diameter of the twisted wires must not exceed 6.0 mm (0.25 in).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.