Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 190 (SUNROOF SYSTEM)REPAIR INSTRUCTIONSSUNROOF MODULE ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE

2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.

Install the sunroof sunshade panel to the sunroof module assembly. Refer to Sunroof Sunshade Replacement .
Install the sunroof window to the sunroof module assembly. Refer to Sunroof Window Replacement .
Install the sunroof motor/actuator to the sunroof module assembly. Refer to Sunroof Motor/Actuator Replacement .

Fig 1: Identifying Sunroof Module Assembly

Courtesy of GENERAL MOTORS CORP.

Position the sunroof module assembly to the vehicle with an assistant.

NOTE: Refer to FASTENER NOTICE .

Install the bolts that retain the sunroof module assembly to the roof panel.
Tighten: Tighten the bolts to 10 N.m (7 lb ft).
Connect the drain hoses to the sunroof module assembly. Refer to the following procedures:
- Sunroof Housing Front Drain Hose Replacement
- Sunroof Housing Rear Drain Hose Replacement

Fig 2: Accessing Sunroof Assembly Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the sunroof harness electrical connector.
Install the headliner. Refer to Headlining Trim Panel Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.