Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
LGM Scan Tool Data List
- Lower Left Ajar Switch
-
The scan tool displays the state of the switch.
- Rear Wiper Mode
-
The scan tool displays OFF, DELAY 1, DELAY 2, ON or WASH. The scan tool displays the commanded state of the rear wiper motor by the liftgate control module.
- Requested Rear Wiper
-
The scan tool displays OFF, DELAY 1, DELAY 2, ON or WASH. The scan tool displays the current rear wiper switch position determined by the switch position data received by the liftgate control module from body control module (BCM).
- Upper Left Ajar Switch
-
The scan tool displays the state of the switch.
- Upper Right Ajar Switch
-
The scan tool displays the state of the switch.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.