Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 178 (LIGHTING SYSTEMS)COMPONENT LOCATORLIGHTING SYSTEMS CONNECTORSHEADLAMP SWITCH C2
2006 Isuzu Ascender S, 5.3 M, 4WD
Headlamp Switch C2
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Headlamp Switch C2
WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
Headlamp Switch C2 Connector Parts Information
Connector Part Information
|
Terminal Part Information
|
Headlamp Switch C2 Connector Terminal Identification
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| A | OG | 192 | Front Fog Lamp Switch Signal (T96) |
| B | L-BU | 187 | Rear Fog Lamp Switch Signal (T79) |
| C | D-GN/WH | 1317 | Front Fog Lamp Relay and Indicator Control (T96) |
| D | YE | 1977 | Rear Fog Lamp Relay and Indicator Control (T79) |
| E | TN | 5463 | Daytime Running Lamp Override Indicator (w/o WX7) |
| F | D-GN | 189 | Headlamp Leveling Motor Supply Voltage (TR6) |
| G | PK | 639 | Ignition 1 Voltage (TR6) |
| H | BN/WH | 1871 | Headlamp Washer Switch Signal (CE4) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.