Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 173 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Isuzu Ascender S, 5.3 M, 4WD
Fastener Tightening Specifications
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Antenna Bracket to Roof Panel Screw | 2.5 N.m | 22 lb in |
| Amplifier Retaining Bolts | 10 N.m | 88 lb in |
| Digital Radio Antenna Retaining Nut | 6 N.m | 53 lb in |
| Navigation Control Processor Bracket to Rear Seat Stud Nut | 45 N.m | 33 lb ft |
| Noise Cancellation Microphone Screws | 0.8 N.m | 7 lb in |
| OnStar® Microphone to Overhead Console screws | 0.8 N.m | 7 lb in |
| Personal Message Recorder Screws | 0.8 N.m | 7 lb in |
| Radio Antenna Cable Mounting Bolts | 8 N.m | 70 lb in |
| Radio Antenna Mast | 5 N.m | 44 lb in |
| Radio Antenna Module Retaining Screw | 2.5 N.m | 22 lb in |
| Radio Front Speaker Mounting Screws | 2 N.m | 18 lb in |
| Radio Rear Speaker Mounting Screws | 2 N.m | 18 lb in |
| Radio Upper Speaker Mounting Screws | 2 N.m | 18 lb in |
| Radio to Instrument Panel Mounting Screws | 2 N.m | 18 lb in |
| Video Display Retaining Bolts | 9 N.m | 80 lb in |
| Video Player Bracket Retaining Bolts | 10 N.m | 88 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.