Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Quick Release Tab
    GM754990Courtesy of GENERAL MOTORS CORP.
  1. If installation of the mounting bracket is required, install the mounting bracket to the overhead console.
  2. NOTE: Refer to FASTENER NOTICE .
  3. Install the 2 OnStar® microphone retaining screws.

    Tighten:  Tighten the screws to 0.8 N.m (7 lb in).

  4. Install the microphone to the mounting bracket ensuring the quick release tab (1) is fully seated.
  5. Fig 2: Identifying OnStar Microphone Components
    GM741633Courtesy of GENERAL MOTORS CORP.
  6. Connect the electrical connector to the OnStar® microphone (1).
  7. Install the overhead console. Refer to Roof Console Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.