SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 173 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)REPAIR INSTRUCTIONSCOAXIAL CABLE REPLACEMENT - CELLULAR TELEPHONEREMOVAL PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Removal Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition to the OFF position.
  2. Remove the right rear seat cushion. Refer to Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Rainier) .
  3. Remove the communication interface module. Refer to Communication Interface Module Replacement (TrailBlazer EXT, Envoy XL)  or Communication Interface Module Replacement (TrailBlazer, Envoy, Rainier) .
  4. Remove the navigation control processor bracket. Refer to Navigation Control Processor Bracket Replacement (TrailBlazer EXT/Envoy XL)  or Navigation Control Processor Bracket Replacement (TrailBlazer/Envoy/Rainier) .
  5. Pass the cellular telephone coax cable through the carpet opening.
  6. Remove the seat back, left and right side. Refer to Seat Back Replacement - Rear No. 1 .
  7. Remove the front door sill plates. Refer to Front Side Door Sill Plate Replacement .
  8. Remove the rear door sill plates. Refer to Rear Side Door Sill Plate Replacement .
  9. Remove the center pillar trim panels. Refer to Center Pillar Garnish Molding Replacement .
  10. Remove the rear quarter upper trim panels. Refer to Rear Quarter Upper Trim Panel Replacement (TrailBlazer, Envoy) .
  11. Remove the lower rear quarter trim panels. Refer to Trim Panel Replacement - Rear Quarter - Left or to Trim Panel Replacement - Rear Quarter - Right .
  12. Remove the left coat hook. Refer to Coat Hook Replacement .
  13. Remove the tool kit carrier.
  14. Remove the child restraint tether anchors. Refer to Child Restraint Tether Anchor Replacement - Rear No. 1 .
  15. Lift and fold the carpet over the bucket seats.
    16. Fig 1: View Of Coax Cable Fasteners In Floor Panel
    GM826146Courtesy of GENERAL MOTORS CORP.
  16. Remove the coax cable fasteners from the floor panel.
    17. Fig 2: View Of Coax Cable Fasteners In Third Left Pillar
    GM826148Courtesy of GENERAL MOTORS CORP.
  17. Remove the coax cable fasteners from the left third pillar.
    18. Fig 3: Identifying Coax Cable & Window Mounted Coupling
    GM826144Courtesy of GENERAL MOTORS CORP.
  18. Disconnect the coax cable (1) from the window mounted coupling.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.