Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
- Install the radio antenna cable assembly to the vehicle.
- Pass the antenna cable and grommet assembly through the fender opening.
- Install the radio antenna cable assembly retaining screws.
Tighten: Tighten the radio antenna cable assembly screws to 2.8 N.m (25 lb in).
- Close the hood.
- Install the antenna mast. Refer to Fixed Antenna Mast Replacement .
- Reach up behind the wheelhouse panel and pass the end of the radio antenna cable assembly through the cowl opening (1).
- Install the antenna cable grommet assembly to the cowl opening.
- Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement (Front End) .
- Install the radio antenna cable (2) to the radio extension cable.
- Close the I/P compartment.
NOTE:
Refer to FASTENER NOTICE
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.