Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test Description
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Test Description
WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
The number below refers to the step number on the diagnostic table.
- 2: This step checks that the VCIM is sending out the proper supply voltage.
DTC B2476
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: OnStar Schematics Connector End View Reference: Entertainment/Communication Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
9 V | Go to Step 4 | Go to Step 3 |
| 3 | Test the keypad supply voltage circuit for an open or short to ground. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 8 |
| 4 | Test the keypad supply voltage circuit for a short to voltage. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 5 |
| 5 | Test the keypad ground circuit for an open. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 6 |
| 6 | Test the keypad signal circuit for a short to voltage. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 7 |
| 7 | Inspect for poor connections at the harness connector of the rearview mirror. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 9 |
| 8 | Inspect for poor connections at the harness connector of the vehicle communication interface module (VCIM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 10 |
| 9 | Replace the rearview mirror. Refer to Rearview Mirror Replacement
. Did you complete the replacement? |
- | Go to Step 11 | - |
| 10 | Replace the VCIM. Refer to Control Module References
for replacement, setup and programming. Did you complete the replacement? |
- | Go to Step 11 | - |
| 11 |
|
- | Go to Step 2 | System OK |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.