SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 161 (ENGINE EXHAUST SYSTEM)REPAIR INSTRUCTIONSEXHAUST SYSTEM REPLACEMENTINSTALLATION PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac Torrent and 2007 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Exhaust System
    GM1370521Courtesy of GENERAL MOTORS CORP.
  1. Position the exhaust system (4) to the vehicle and install the rubber isolators (5, 6, 7) to the hangers (1, 2, 3).
    2. Fig 2: View Of Gasket & Exhaust Pipe
    GM926819Courtesy of GENERAL MOTORS CORP.
  2. Install the new gasket onto the catalytic converter pipe flange.
    3. NOTE: Refer to Fastener Notice .
  3. Assemble the exhaust system pipe to the catalytic converter pipe and install new nuts.

    Tighten:  Tighten the nuts to 37 N.m (27 lb ft).

  4. Check the entire exhaust system for leaks.
  5. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.