SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 142 (POWER STEERING SYSTEM)COMPONENT LOCATORPOWER STEERING CONNECTORSPOWER STEERING CONTROL MODULE (PSCM) C4
2006 Isuzu Ascender S, 5.3 M, 4WD

Power Steering Control Module (PSCM) C4

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Power Steering Control Module (PSCM) C4
WARNING: This page is about a different car, the 2007 Pontiac Torrent and 2007 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Power Steering Control Module (PSCM) C4 Connector End View
GM1866124Courtesy of GENERAL MOTORS CORP.
Power Steering Control Module (PSCM) C4 Connector Parts Information

Connector Part Information 
  • OEM: 1565287-1
  • Service: 19168086
  • Description: 12-Way F 0.64 Unsealed (NA)
Terminal Part Information 
  • Pins: 1, 2
  • Terminal/Tray: 1123343-2/7
  • Core/Insulation Crimp: Pins 2, 8 - K/K
  • Release Tool/Test Probe: J-38125-24/J-35616-64B (L-BU)
Power Steering Control Module (PSCM) C4 Connector Terminal Identification

Pin Wire Color Circuit No. Function
1 TN/BK 2500 High Speed GMLAN Serial Data Bus+
2 TN/BK 2500 High Speed GMLAN Serial Data Bus+
3-5 - - Not Used
6 L-BU 5986 Serial Data Communications Enable
7 L-BU 2501 High Speed GMLAN Serial Data Bus-
8 YE 2501 High Speed GMLAN Serial Data Bus-
9-12 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.